11
2.1
With the door fully open, place
a 1-1/2 inch (3.8 cm) board
(or a 2x4 laid fl at) on the fl oor,
centered under the garage door.
Test the Safety Reversal System
2.2
Press the remote control push
button to close the door. The door
MUST reverse when it makes
contact with the board.
If the door stops and does not reverse on
the obstruction, increase the down travel
(refer to Adjustment Step 1).
Repeat the test. When the door reverses
upon contact with the 1-1/2 inch board,
remove the board and open/close the door 3
or 4 times to test the adjustment.
If the test continues to fail, call a trained
door systems technician.
Without a properly installed safety
reversal system, persons (particularly
small children) could be SERIOUSLY
INJURED or KILLED by a closing
garage door.
• Safety reversal system MUST be
tested every month.
• After ANY adjustments are made,
the safety reversal system MUST
be tested. Door MUST reverse on
contact with 1-1/2" high (3.8 cm)
object (or 2x4 laid fl at) on the fl oor.
2
Test the Protector System
®
3.1
Open the door. Place the garage
door opener carton in the path
of the door.
The garage door opener will not close
from a remote control if the LED in either
safety reversing sensor is off (alerting you
to the fact that the sensor is misaligned or
obstructed).
If the garage door opener closes the
door when the safety reversing sensor is
obstructed (and the sensors are no more
than 6 inches [15 cm] above the fl oor), call
for a trained door systems technician.
Without a properly installed safety
reversing sensor, persons (particularly
small children) could be SERIOUSLY
INJURED or KILLED by a closing
garage door.
3.2
Press the remote control push
button to close the door. The door
will not move more than an inch
(2.5 cm), and the garage door
opener lights will fl ash 10 times.
3
Adjustment
2