®
GATE LOCK
MODEL 915GA
BEFORE STARTING
Read and follow all instructions. Check the carton inventory.
Mounting hardware is not provided. Refer to a local hardware store for
necessary mounting hardware.
• The gate lock is designed to use 5/16" diameter mounting hardware.
• For tubular gates, the following items are needed: carriage bolts,
washers, and nuts.
• For chain link gates, the following items will be needed: U-bolts,
carriage bolts, washers, and nuts.
Ensure that the gate closes properly. When the gate lock and gate bracket
are properly aligned, the gate lock will latch onto the gate bracket pin.
NOTE:
Some installations may require the gate bracket to be recessed in
the mounting post so the bracket and lock will be flush and lock properly.
Instead of recessing the gate bracket, a spacer may be added between the
gate lock and the gate.
Size the spacer before attempting to mount the gate lock. If installing the
gate lock on a Push-to-Open gate, the gate lock must be installed on the
opposite side of the gate.
PULL-TO-OPEN GATE
PUSH-TO-OPEN GATE
Gate Bracket Pin
Cotter Pin
Gate Bracket
Gate Lock
Washer
Keys (2)
Cable Ties (6)
Watertight Connector (1)
CARTON INVENTORY
To avoid SERIOUS personal INJURY or DEATH from electrocution:
• Disconnect ALL electric and battery power BEFORE performing
ANY service or maintenance.
• This device is for use ONLY with Chamberlain
®
gate operator
models GA400D and GA420D.
• Read and follow ALL instructions.
• Have gate in full closed position BEFORE installing the gate lock.
ATTENTION
AVERTISSEMENT
AVERTISSEMENT
AVERTISSEMENT
WARNING
CAUTION
WARNING
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA
ADVERTENCIA
The 915GA Automatic Gate Lock is compatible with Chamberlain
®
Gate
Access Systems GA400D and GA420D. The purpose of the automatic
gate lock is to securely lock the gate in the closed position.
1
Gate bracket must be
recessed so that the
gate lock sits flush.
Mounting Post
Label (1)
Spacer
Open
Spacer
Mated Lock
and Bracket
Gate Bracket
