*3-Button Remote
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security
✚
®
3-Button remote or
mini-remote can be
programmed to operate
other Security
✚
®
garage
door openers.
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote, first erase all
codes: Press and hold the “learn”
button on motor unit until the learn
indicator light goes out (approximately
6-9 seconds). All previous codes are
now erased. Reprogram each remote
or keyless entry you wish to use.
LOCK
LIGHT
PROGRAMMING
NOTICE:
If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
®
remote controls.
To Add or Reprogram a Hand-held
Remote Control
USING THE “LEARN” BUTTON
Reprogramming Light or Additional
Light
Your garage door opener remote work light has already
been programmed at the factory to operate with your
opener. Any additional or replacement remote work lights
will need to be programmed.
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
1. Press the “learn button” on light
until LED comes ON.
2. Activate the garage door using the
hand-held remote, wall control or
keyless entry.
3. It has learned the code and the light
turns on.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or remote control are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
