8
gaRagE DOOR OPEnERS
Programming to a garage Door Opener with a Program/LEaRn Button
The Program/LeaRn button is typically located on the back or side panel of the garage door opener or an external receiver. For
help locating your Program/LeaRn button contact your garage door opener manufacturer.
If you have a LiftMaster or Chamberlain branded garage door opener with a yellow learn button, press and release the learn
button, then press and hold the button on the remote control you would like to use. If programming is not successful, proceed
through the steps below.
If you have a Genie
®
Intellicode
®
2 garage door opener go to the next page.
The images throughout this manual are for reference only and your product may look different.
Bottom Button
1
Start with your garage door closed.
2
Press and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
3
Press and release the Program/LEARN button on your
garage door opener.
4
On the remote control, press and release the button that
you would like to program twice. The blue LED will blink
for up to 60 seconds.
5
6
Wait for the garage door to move, then press and release
either of the buttons on the remote.
LED
Test the remote control by pressing the button you
programmed in step 4. If the garage door opener does not
activate, repeat the programming steps.
IMPORTANT:
The remote will activate your garage door during
programming. Ensure garage door is clear of ALL obstructions.
LED
