Adjustment Step 4
Test the Safety Reverse System
Test
• Place a one-inch board (or a 2x4 laid flat) on the floor,
centered under the garage door.
• Operate the door in the down direction. The door must
reverse on striking the obstruction.
Adjustment
If the door stops on the obstruction, it is not traveling far
enough in the down direction.
• Increase the DOWN limit by turning the DOWN limit
adjustment screw counterclockwise 1/4 turn.
• Repeat the test.
On a sectional door, make sure limit adjustments do
not force the door arm beyond a straight up and down
position. See the illustration on page 22.
• When the door reverses on the one-inch board, remove
the obstruction and run the opener through 3 or 4
complete travel cycles to test adjustment.
If the door will not reverse after repeated adjustment
attempts, call for professional garage door service.
Important Safety Check
Repeat Adjustment Steps 1-4 after:
• Each adjustment of door arm length, force controls or
limit controls.
• Any repair to or adjustment of the garage door
(including springs and hardware).
• Any repair to or buckling of the garage floor.
• Any repair to or adjustment of the opener.
1 Inch Obstruction
Failure to test and adjust the safety reverse system may
result in serious injury or death to persons trapped by a
closing garage door. Repeat this test once a month and
adjust as needed.
26
Adjustment Step 3
Test The Protector System
®
• Press the remote control push button to open the door.
• Place the opener carton in the path of the door.
• Press the remote control push button to close the door.
The door will not move more than an inch, and the
opener light will flash for 5 seconds.
Professional service is required if the opener closes the
door when the safety reversing sensor is obstructed.
The garage door opener will not close from a remote if
the indicator light in either sensor is off (alerting you
to the fact that the sensor is misaligned or obstructed).
The garage door can be closed by pressing and holding
the Door Control push bar or button until down travel is
completed.
Safety Reversing Sensor
Safety Reversing Sensor
Without a properly working safety reversing sensor,
persons (particularly children) could be seriously injured
or killed if trapped by a closing garage door. Repeat this
test once a month.
One-Inch board (or a 2x4 laid flat)
WARNING
CAUTION
WARNING
WARNING
CAUTION
WARNING
Header Bracket
Rail Bracket
Foam Packaging
Opener Carton or
Temporary
Support
Header Wall
Garage
Door
Rail
Clevis Pin
5/16" x 2-3/4"
Ring Fastener
Clevis Pin
5/16"x2-3/4 "
Ring Fastener
Header Bracket
Rail
Bracket
Rail
• Position the opener on the garage floor below the
header bracket. Use packing material as a protective
base.
If the door spring is in the way you’ll need help. Have
someone hold the opener securely on a temporary
support to allow the rail to clear the spring.
• Position the rail bracket against the header bracket.
• Align the bracket holes and join with a clevis pin as
shown.
• Insert a ring fastener to secure.
11
Installation Step 3
Attach the Rail to the Header Bracket
Hardware Shown Actual Size
