APR 2018
CMT-330TC Three-Knife Trimmer
2-2
2. Installation Guide
2.1 Shipping Claims
The CMT-330TC has been packed to prevent
damage during shipment. Claims for damage or
loss are the responsibility of the recipient. In-
spect all shipments as soon as they are re-
ceived. If there is any noticeable damage, note
it on the freight bill. Visual and/or hidden dam-
age must be reported to the claims department
of the carrier within 15 days. Contact your
dealer if you need any assistance. Check the
contents of the crate against both the packing
list on page 1-5 and the freight bill. Make sure
there are no missing items.
2.2 Unpacking
Remove the packing materials and the four lag
screws. Lag screws are located in the frame,
behind each of the lower side doors as shown in
Figure 2-1.
Figure 2-1. Lag Screw Locations
Remove Lag Screws
1. Remove the four screws from each of the
two lower front side doors using a 1/8" hex-
drive wrench.
2. Using a 9/16" wrench, remove the lag
screws from the two front locations shown in
Figure 2-1.
3. Open the two lower rear side doors and re-
move the waste bins.
4. Remove the two rear lag screws from the
two rear locations shown in Figure 2-1.
5. Reinstall the waste bins and close the rear
side doors.
6. Reinstall the two front side doors.
Use a forklift to remove the machine from the
skid and place it as close as possible to its in-
stallation location. The machine has accessory
power cables and air hoses wrapped-up and
placed inside the machine. Be careful not to
pinch or entangle these in the forks.
Figure 2-2. Fork Locations for Lifting
2.3 Moving
Once the machine is near its final location, it can
be rolled into place.
WARNING
Do not roll on a graded surface. Roll only on
a flat surface. Personal injury could result.
It may be necessary to raise the six leveling
pads in order to roll the machine. A pad is lo-
cated under each corner of the machine and the
center of each side. Using either a 3/4" open-
ended wrench or an adjustable wrench, turn the
leveling pad counterclockwise to raise it.
Figure 2-3. Leveling Pads
Push the CMT-330TC into position. Do not
lower the leveling pads at this time. Its final po-
sition may require slight adjustment depending
upon the setup.
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
