HELPLINE NO 08448012949
8
OrIgINaL INstructIONs
2. Dust cOLLEctION Bag (see Fig. D, E)
Your sander is equipped with a Dust Collection
Bag. To attach, insert the dust collection bag into
the back of the sander in correct position, and
make sure the bag is tightened securely on the
dust extraction nozzle.
(see Fig. D)
To empty the Dust Collection Bag, take the Dust
Collection Bag. Then pull out the bag (See Fig.
E1), and shake out dust, shown in Fig E2.
OPEratINg INstructIONs
NOtE:
Before using the tool, read the
instruction book carefully.
INtENDED usE
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. a)FIttINg tHE saNDINg PaPEr (see Fig.
a, B & c)
Fit the sanding paper over the base. Make sure
the sanding paper is even with the edges and that
the dust collection holes in the base and sanding
paper is aligned and that the sanding paper is
taut on the base.
Lift the sanding paper retaining clips to the open
position and insert one end of the sanding paper
under the retaining clip.
Push the clip back into the retaining position.
Lightly stretch the paper over the base plate
ensuring that it is not folded or wrinkled then
position under the other retaining clip back into
the retaining position. Check that the paper is
flat to the base plate, if not, release either clip
and reposition the paper before resetting the clip.
Switch on momentarily to check that the sander
is functioning correctly. If there is undue vibration,
repeat the paper positioning procedure.
b) FIt saNDINg PaPEr WItH HOOK & LOOP
sYstEM
The sanding papers are placed directly onto the
base plate (5). The hole pattern in the sanding
plate and sanding paper must match.
Before placing on the sanding paper, free the
base plate (5) from dust/debris by lightly tapping
against it.
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E1
Fig. E2
Fig. G
Fig. H
Fig. F
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E1
Fig. E2
Fig. G
Fig. H
Fig. F
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E1
Fig. E2
Fig. G
Fig. H
Fig. F
