HELPLINE NO 08454 505299
11
ORIGINAL INSTRUCTIONS
11. Operating Instructions
• Apply the power tool to the screw only
when it is switched off. Rotating tool inserts
can slip off.
7. Adjusting the Speed
The speed of the switched on power tool can
be variably adjusted, depending on how far
the On/Off switch 7 is pressed.
8. LCD battery level display
When press the On/Off switch 7, the LCD
display 10 indicates the battery level.
9. Run-on Brake
When the On/Off switch 7 is released, the
chuck brakes to a stop, thus preventing the
run-on of the tool.
When driving in screw, wait until the screw is
screwed in flush with the material and then
release the On/Off switch 7. By doing so, the
head of the screw does not penetrate into the
material.
10. Protection Against Deep
Discharging
The Li-ion battery is protected against deep
discharging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the
machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.
12. Soft Grip
The gripping surface (soft grip 4) reduces the
danger of slipping and thereby improves the
grip on the machine and the handling.
At the same time, the rubber coating achieves
a vibration-reducing effect.
3. Switching off:
To stop the appliance, release the On/Off
switch 7.
4. Reversing the Rotational Direction
The rotational direction switch 6 is used to
reverse the rotational direction of the machine.
However, this is not possible with the
On/Off switch 7 actuated.
5. Setting the Torque
The required torque can be preselected in 16
steps with the torque preselection ring 2.
With the correct setting, the insert tool is
stopped as soon as the screw is screwed flush
into the material or when the set torque is
reached.
If you are going to drill a hole in wood or steel
set the torque ring to the symbol “Drilling” .
6. Gear Selection, Mechanical
Gear 1:
Low speed range; for screwdriving or
working with large drilling diameter.
Gear 2:
High speed range; for working with small
drilling diameter.
If the gear selector 3 cannot be fully engaged,
lightly rotate the driver spindle with the drill
bit by twisting the drill chuck.
•
Actuate the gear selector 3 only
when the machine is at a
standstill.
Two speed ranges can be
preselected with the gear selector 3.
Light pressure on the On/Off switch 7 results
in a low rotational speed. Further pressure on
the switch results in an increase in speed.
If you are going to drill a hole in masory,l
set the torque ring to the symbol “Hammer” .
