Chapter 2
9
FD1 (Floppy Disk Connector)
This connector is used to connect 34 pins of Floppy.
IDE1 / 2 (IDE Hard-Disk Connector)
This connector is used for connecting 40 pins of ATAPI devices.
IDE 1 only connects two IDE devices. (
Primary
Master/Slave)
IDE 2 only connects two IDE devices. (
Secondary
Master/Slave)
Chapter 2
10
JP1 (Clear CMOS Data)
To clear the contents of the CMOS, please follow the steps below.
1. Disconnect the system power supply from the power source.
2. Set the jumper cap at location [
2-3
] for <
5 seconds
>, and then set it back to the
default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load Setup Defaults. Type [
Y
] and
press [
enter
].
5. Set the system configuration in the Standard CMOS Setup menu.
JP8 (On board Audio Enable/Disable)
This function allows you to enable or disable the on board audio. You must set the
jumper cap to pins
1-2
to
enable
or set pins
2-3
to
disable
this function.
Pin
Definition
1-2 Normal (default)
2-3 Clear CMOS Data
Pin Definition
1-2 Enable
(default)
2-3 Disable
