Hardware Setup
9
Auxiliary Audio-in (CN3)
This connector is for use with a secondary CD-ROM, DVD-ROM
or CDR/CDRW disk drive.
Audio Mono-in/out (CN4)
This connector is used for Add on Card e.g. modem with Mono
in/out connector.
WOL (Wake-on-LAN) Connector (CN5)
Enable the Wake Up On LAN selection in BIOS's Power
Management Menu to use this function. This header is used
to connect an add-in NIC (Network Interface Card) which gives
WOL capability to the mainboard
Blue LED Connector(CN17)
This feature work entirely the same as
the power indicator LED,
both shows the system's power status. The only difference
is that this one is blue while the other is red LED.
USB 0/1 Ports and USB 2/3 Connector (USB1/CN20)
If you want to use a USB Keyboard, you must enable the USB
keyboard support function in BIOS's Integrated Peripherals menu
(See Section 3-4). This board contains a USB Host controller and
includes a root hub with two USB 0/1 ports a connector for
optional USB Adaptor (USB 2/3).
Front Panel Audio Connector (CN22)
This connector give you the option of a front panel audio jack
cable ext. to be plug into a special custom designed system case.
Simply remove the two jumper cap at pin 6-13 and 7-12 then plug
it into the (optional) cable ext. connector. Pin 6-13 and 7-12 are
shorted (default) to enabled the back panel audio function.
IR Connector (IR1)
Select a UART Mode in BIOS's Integrated Peripherals menu the
UART port to support IR/CIR functions. (See section 3-4)
