6
INSTALLATION INSTRUCTIONS
•
To clean the Braai Grids remove from the appliance and soak in hot
detergent solution or place in the dishwasher. Braai Grids may be cleaned
with ”Scotch Brite” scouring pads. Rinse well in clean water before placing
the parts back into the appliance.
•
Avoid contact with aggressive chemicals.
•
Don’t use oven cleaners.
•
Don’t store any chemicals (especially pool chemicals) close to your braai.
•
This appliance requires a shut-off valve to be fitted in a convenient position
for the customer.
•
This appliance requires a minimum of 1m copper pipe to be fitted directly
onto the compression fitting located at the gas inlet.
•
This appliance requires an operating pressure of 2,8 kPa for LP Gas and 2.1
kPa for Natural Gas. A suitable regulator that complies with the requirements
of SANS 1237 must be installed outside. Ensure that the flow capacity of the
installed regulator is sufficient to drive the model to be installed.
•
It is preferable that the Sizzler Grill be installed in the open and any surrounds
are of a non-flammable material. If installed in a structure that can be
damaged with heat, ensure that a suitable flame retardant buffering is
used. The manufacturer will not accept any responsibility if the installation
instructions re safety clearances are not adhered to.
•
Where a flue or fume extraction device is deemed to be required, contact
the manufacturer for information on these products. Where the appliance is
installed inside then it is recommended that such a device be fitted prior to
commissioning the appliance and handing it over to the user.
•
Before lighting the appliance for the first time ensure that there are no gas
leaks and that a pressure test is done.
•
The Gas installer is required to light the burners in the presence of the
owner/ user and to instruct that person in the safe operation of the appliance
and the complete installation.
•
It is particularly important to show the user the position of the isolator valve
•
Installers are required to provide the owner/user with a completion
certificate which must be dated and signed by both parties. Ensure that your
name and SAQCC number appear on the certificate.
SERVICING
Your local dealer will gladly handle any concern that you have and will take the
appropriate action. Spares are readily available countrywide.
Summary of Contents for SGG320
Page 10: ...7...
