7
G
E
T
T
IN
G
S
T
A
R
T
E
D
S
A
F
E
T
Y
/
S
P
E
C
IF
IC
A
T
IO
N
S
A
S
S
E
M
B
L
Y
/
IN
S
T
A
L
L
A
T
IO
N
O
P
E
R
A
T
IO
N
T
R
O
U
B
L
E
S
H
O
O
T
IN
G
M
A
IN
T
E
N
A
N
C
E
/
R
E
P
A
IR
OPERATION
Always wear safety glasses complying
with U.S. ANSI Z87.1 before beginning any
power tool operation.
Do not operate this machine before
properly lubricating the machine. Failure
to lubricate the machine before using can cause damage to
the machine.
If the temperature exceeds the maximum
operating temperature (see ) wait until
cool.
Do not use the press with no load and when
the piston rod is on the up dead position.
NOTE:
The machine is adjusted to produce proper pressure at
the factory.
Using the press
1.
Ensure that the piece to be pressed is centered on the table
with respect to the piston.
Pieces to be pressed must have a
compact, solid structure and must not be
subject to crumbling or other structural damage potential.
And do not activate the press with no load.
2.
Before starting the pump, ensure the direction valve handle
is set to the center position.
3.
Turn the motor on by pressing the “ON” button as shown
below. Pressing the “OFF” button will shut the motor off.
On/Off
Switch
Direction
Control
Lever
4.
The piston is controlled by a direction control lever (with a
red ball handle) shown above. The lever has 3 states:
•
Left : Up
•
Middle: Stop
•
Right: Down
When using the press beware of any part
that could be ejected out the front, by the
force applied.
Adjusting the table height
1.
Unload the table of all extra items.
2.
Lift the table support beam on one side. We recommend
asking for assistance in holding the beam, although it is
possible to do so only by oneself.
3.
Extract the support pin as shown below.
4.
Insert the pin into the next adjacent hole, either above or
below the original hole. Make sure to insert the pin all the
way through both the front and back of the hydraulic press
frame.
5.
Then ease the support beam back onto the pin. When done
this way, only one person is required.
6.
Repeat all previous steps for the opposite side.
7.
Repeat until the desired height achieved.
