Page: 57/81 User Manual PSU-CTRL-2D, Rev.1-00: Software Interface
Tab. 12. Status bits of the PSU modules.
Bit Value
Description
0
ST_ILIM_CTRL
control of the inrush current limiter
1
ST_LED_CTRL_R
red LED color is on
2
ST_LED_CTRL_G
green LED color is on
3
ST_LED_CTRL_B
blue LED color is on
4
ST_PSU0_ENB_CTRL control enable PSU #0
5
ST_PSU1_ENB_CTRL control enable PSU #1
6
ST_PSU0_FULL_CTRL control full range of PSU #0
7
ST_PSU1_FULL_CTRL control full range of PSU #1
8
ST_ILOCK_OUT_DIS
disable interlock at output connector
9 ST_ILOCK_BNC_DIS disable
interlock at BNC connector
10 ST_PSU_ENB_CTRL
control enable PSUs
11 –
–
12 ST_ILIM_ACT
state of inrush current limiter
13 ST_PSU0_FULL_ACT state of full range of PSU #0
14 ST_PSU1_FULL_ACT state of full range of PSU #1
15 ST_RES_N
state of the reset signal RESn
(if 0, device is reset)
16 ST_ILOCK_OUT_ACT evaluated state of interlock at output
connector
17 ST_ILOCK_BNC_ACT evaluated state of interlock at BNC
connector
18 ST_ILOCK_ACT
interlock
state
19 ST_PSU_ENB_ACT PSUs
enabled
20 ST_PSU0_ENB_ACT
PSU #0 enabled
21 ST_PSU1_ENB_ACT
PSU #1 enabled
22 ST_ILOCK_OUT
state of interlock at output connector
23 ST_ILOCK_BNC
state of interlock at BNC connector
CGC Instruments
Tel.: +49 (371) 355 098–55
Hübschmannstr. 18 | D–09112 Chemnitz
Fax: +49 (371) 355 098–60
internet: www.cgc-instruments.com
e–mail: [email protected]
