50
52675
OPERATION
The tool can be plugged into any socket-outlet (with 230 V AC) that is equip-
ped with a 10A fuse or higher. The socket-outlet has to be safeguarded by an
earth leakage circuit breaker (ELCB). The operating current must not exceed
30mA. Insert the tool plug into the power cord coupling (extension). Secure
the power cable with the strain-relief clip found on the equipment. To switch
on the equipment hold the safety lock-off and press and hold the ON/OFF
switch. To switch off, release the ON/OFF switch.
One wire brush and one plastic brush are supplied with the equipment. The
wire brush is suited for use on robust surfaces and obstinate weeds. We
recommend using the plastic brush for light vegetation and surfaces too sen-
sitive for the steel brush.
Important
Always carry out a short trial run to check out possible effects on the
surfaces of the paving stones or slabs before starting with your work.
Never use the equipment on very sensitive surfaces, for example tiles.
Important
Only use brushes which are in good condition. Replace excessively worn
or damaged brushes immediately.
Always use both hands to operate the equipment.
Guide the equipment along the joints at a walking pace.
For uniform results, carry out your work at a constant speed.
If necessary, guide the equipment along the same joint several times.
MAINTENANCE AND STORAGE
Replacing the power cable
If the power cable for this equipment is damaged, it must be replaced by the
manufacturer or its after sales service or a similarly trained person to remain
safe to use.
Cleaning, maintenance and ordering of spare parts
Always pull out the power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust
as far as possible. Wipe the equipment with a clean cloth or blow it down
with compressed air at low pressure. We recommend that you clean the
equipment immediately after you use it. Clean the equipment regularly with
a damp cloth and some soft soap. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts in the equipment. Ensure that no
GB
Summary of Contents for 52675
Page 54: ...54 52675...
Page 55: ...55 52675...
