Cetetherm Mini Plus CM737
Installation, service and operating instruction
30
13.4.1 Changing pump curve setting
Picture 16, Serial curve setting
1. Push the button for two seconds
Pump goes to setting mode - LED starts flashing.
2. With each push, the setting changes:
LED 1-2-3 are permanently on, and then the control curve and mode is changed.
3. Flashing mode:
•
Fast: Proportional pressure
•
Slow: Constant pressure/power
4. After ten seconds not pushing the button:
•
Setting is adapted.
•
Pump returns to operating mode
5. LED 1 or 2 or 3 is permanently on.
•
Pump is running with the selected curve and mode.
