Fitting the wall terminals
40
OMEGA Mifare wall terminals
Fitting the WT-M-II wall terminal
The WT-M-II control module and the reader module are
supplied preassembled. Before mounting, the control module
and the reader module must first be disassembled.
Follow the steps for disassembling the WT-M-II wall terminal
on pages 33.
For fitting the WT-M-II control module without the fitting
frame, you need already installed and prepared in-wall switch
boxes. All required cable connections must already be
available in the switch boxes. The supplied fitting frame is not
required in this case.
If you are using fitting frames, please follow the fastening
instructions on page 35 ff.
Ensure that the in-wall switch boxes have been installed
horizontally.
The mounting holes of the wall terminal must always
be aligned horizontally, also when the wall terminal is
installed on in-wall switch boxes.
Ensure that all required cables have been guided through
the switch boxes without being damaged or squeezed.
Establish all required wire connections as described in the
"Connections" chapter on page 26.
