REGULATORY COMPLIANCE
FCC
The GPRS modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration,
which demonstrated that it
complies with Part 15 emission limits. The GPS-207 uses an Enfora
manufactured GPRS modem. FCC Part 22 & Part 24 is covered by the "modular approval"
process for a transmitter. This approach, described by FCC Public Notice DA 00-131407
released June 26, 2000, is intended to afford relief to equipment manufacturers by eliminating
the requirement for obtaining a new equipment authorization for the same transmitter when
installed in a new device.
In order to approve it without additional FCC certification approvals, the installation must meet
the following conditions:
For the transmitter to meet the MPE categorical exclusion requirements of 2.1091,
the ERP must be less than 1.5 watts for personnel separation distance of at least 20
cm (7.9 in). Therefore, the maximum antenna gain cannot 3.3dBi. If greater
than 1.5 watts exists, then additional testing and FCC approval is required.
R&TTE -
The GPRS modem has been fully tested and complies with all the requirements of EN301 489-1,
EN301 489-7 and EN60950-1:2001. Compliance to EN301 511 has been demonstrated by
testing on the GPS-207.
Disclaimer
The information and instructions contained within this publication comply with all FCC, GCF,
PTCRB, R&TTE, IMEI and other applicable codes that are in effect at the time of publication.
The GPS-207 uses an Enfora manufactured GPRS modem.
CES Wireless Technologies disclaims all responsibility for any act or omissions, or for breach of
law, code or regulation, including local or state codes, performed by a third party.
CES Wireless Technologies strongly recommends that all installations, hookups, transmissions,
etc., be performed by persons who are experienced in the fields of radio frequency technologies.
CES Wireless Technologies acknowledges that the installation, setup and transmission
guidelines contained within this publication are guidelines, and that each installation may have
variables outside of the guidelines contained herein. Said variables must be taken into
consideration when installing or using the product, and CES Wireless Technologies shall not be
responsible for installations or transmissions that fall outside of the parameters set forth in this
publication.
CES Wireless Technologies shall not be liable for consequential or incidental damages, injury to
any person or property, anticipated or lost profits, loss of time, or other losses incurred by
Customer or any third party in connection with the installation of the Products or Customer's
failure to comply with the information and instructions contained herein.
© CES Wireless Technologies Corp – 2012 Page
2 of 17
