CES ARi-195e, Installation And Operation Manual

Page: 18 / 30

CES SUPPORT 407-679-9440 Page 18 MAN78 © CES 1998
Emergency
The emergency sequence is a received tone sequence that has status digit(s) that match the programmed emergency
status digit(s). See
sequence .
Programming parameters, emergency:
Emergency, status digit 1: Sets the first status digit for the emergency sequence. If programmed to ‘not applicable’
the feature is shut off.
Emergency, status digit 2: Sets the second status digit for the emergency sequence. If programmed to ‘not
applicable’ only status digit 1 must match to receive an emergency sequence
Item Description Range Representation Default
21 Emergency, status digit 1 0 - 16 16 = not applicable 16
22 Emergency, status digit 2 0 - 16 16 = not applicable 16
Polarity
Sets the active state of the input or output.
Programming parameters, polarity:
Polarity, PTT input: Indicates the active level of the PTT input.
Polarity, speaker enable output: Sets the active level of the speaker enable output which is activated when alert
tones are generated.
Item Description Range Representation Default
23 Polarity, PTT input 0,1 0 = active lo, 1 = active hi 0
24 Polarity, speaker enable output 0,1 0 = active lo, 1 = active hi 0
Serial Port
Item Description Range Representation Default
25 RS232 port, baud rate 0 - 4 0 = 300, 1 = 1200, 2 = 2400, 3
= 4800, 4 = 9600 4
26 RS232 port, arbitration 0,1 0 = send immediately, 1 = wait
for poll 0
27 RS232 port, send time and date 0,1 0 = no, 1 = yes 1
28 RS232 port, polling address 0 - 99 1
The RS232 port is designed to allow connection to a serial printer or a computer. The computer connection can
operate in a polled environment.
If the arbitration type is ‘send immediately’ then data sent out the RS232 port is in the same format as the parallel
port . The only difference being that sending of the date and time can be turned off. Data is sent as soon as it is
received. No handshake formats are supported so in this arbitration mode the serial receive line is ignored. All data
is sent even if it is not displayed because the FIFO was full unless the sequence was suppressed.