Functions
1. INPUTS:
The inputs of the CVM0 use a balanced input circuit to help minimize induced noise. These are
designed to handle very high signal voltages of up to 15volts.
2. OUTPUTS:
RCA connectors should be connected to the next component AFTER the CVM0; such as a crossover,
equalizer or amplifier. Remember, the Bass Booster should be connected before a crossover.
3. DASH REMOTE CONTROL
4. POWER CONNECTOR
5. BASS CONTROLS:
These two knobs control the Bass functions of the CVM0 SWEEP knob allows you to choose
the center frequency desired. The WIDE knob adjusts the range of frequency that the Bass Booster will effect.
6. THE PFM SUBSONIC FILTER SWITCH:
The CVM0 utilizes a PFM Subsonic Filter Switch which will help the
speaker control and amplifier power management. This PFM Subsonic Filter Switch comes with three frequencies
selections 35Hz/50Hz/80Hz. On most systems, setting the switch at 35Hz is fine if you want to protect your
speaker system even more, you should try a higher frequency. Often, a higher frequency actually sounds louder
and cleaner.
7. BASS MAXIMIZE INDICATOR:
Three LED indicators flash when the bass maximization circuit is activated.
8. POWER ON LED
