FUSE
+
8 ohm/20 W Resistor
AMPLIFIER
INPUT
TO
CROSSOVER
+
OUTPUT
FROM
CROSSOVER
H4TAK
TWEETER
Tweeter Mounting/Installation
2.36”/60mm
1.57”/40mm
1.18”/30mm
H4TAK PASSIVE CROSSOVER HOUSING
(physical dimensions)
Make sure to connect the output of the amplifier into the input of the crossover, and the output of the crossover to the
tweeter. If hooking up more than one(1) tweeeter use a load resistor to compensate for output levels and impedance.
Thank you for purchasing a Cerwin Vega Mobile product and we hope to provide
you with countless hours of listening enjoyment.
Please take a brief moment to register your new product. By registering your new
product, you will receive benefits such as:
- Important product notifications that may pertain to your purchase.
- Confirmation and record of ownership in case of loss or theft.
- Knowledgeable customer service and technical assistance pertaining to your
product.
Register your new product by completely filling out this Product and Warranty
Registration card or register online at
www.cerwinvegamobile.com.
Registration is voluntary and failure to register will not diminish your limited warranty
rights.
Limited Warranty (U.S.A.)
Cerwin Vega Mobile warrants all of our amplifiers and speakers to be free of defects
in materials and workmanship for a period of one (1) year.
This warranty is non-transferable and applies only to the original purchaser from an
authorized Cerwin Vega Mobile dealer. If service is required and necessary under
this warranty due to manufacturing defect or malfunction, then Cerwin Vega Mobile
will repair and/or replace defective product with either new or remanufactured like
product at no charge at our discretion.
Damage to product caused by the following will not be covered under this warranty:
abuse, accident, misuse, neglect, modifications, repairing attempts, seller/installer
misrepresentation.
This warranty does not cover any incidental, consequential, or cosmetic damage
due to accidents or normal wear and tear, nor does it cover the cost of removing or
reinstallation of the product.
Warranty is void if the product’s serial number has been removed, defaced, and/or
tampered with.
Warranty Procedure:
We recommend that you contact your Cerwin Vega Mobile authorized dealer where
your original purchase was made to initiate all warranty claims. Our authorized
dealers can guide you through the warranty procedure to ensure that your claim will
be processed in a timely manner. All warranty returns must be accompanied with a
proof of purchase (a copy of the original sales receipt) and be shipped freight
prepaid to our facility with an RA (Return Authorization) number clearly marked on
the outside of the package. Direct returns from consumers or non-authorized dealers
will be refused if shipped without a valid RA number authorized by Cerwin Vega
Mobile beforehand.
INTERNATIONAL
Products purchased outside of the U.S.A. are covered only by that country’s
distributor and not by Cerwin Vega Mobile U.S.A.
Please Ship All Warranty Claims With Pre-Authorized RA Number To:
CV&DA Holdings, Inc.
ATTN: Customer Service Department
1225 E. 7th St.
Los Angeles, CA 90021 USA
Please Contact Customer Service for Further Warranty Information:
U.S.A.
Tel: 213-261-4161 / Fax: 213-947-4767
NOTE:
For high powered system applications: 60-100 Watts (RMS) Please use an 8 ohm/20 watt resistor
in series (in-line) with the Tweeter postive terminals (
as shown below - NOT included - Parts Express Part # 017-8
)
! CAUTION !
Hooking the crossover backwards will void the warranty.
