User Manual
©
2019 Cervis, Inc.
7
5.0
Associate with DIN-9XWxR-MOD
The Associate process is used when necessary to establish or re-establish the communication
link with the DIN-9XWxR-MOD receiver. The association process varies depending on the type
of Warrior remote control device you have. Consult your specific remote’s user manual for its
association process.
Note:
DIN-9XWxR-MOD association can only occur during the first two minutes following unit
power-up. If you exceed this two-minute window of opportunity before attempting to Associate
with the handheld transmitter, the attempt will be rejected, and the DIN-9XWxR-MOD must be
powered off and then turned on again, allowing for the two-minute window to reactivate.
Note:
A receiver that is in use with another handheld transmitter cannot be associated.
1. Turn the DIN-9XWxR-MOD on by flipping DIP switch 1 (Power) to the
ON
position (Left).
2. Put the DIN-9XWxR-MOD into association mode by flipping DIP switch 4 (Association)
to the
ON
position (Left).
The ASC LED flashes, indicating that the module is in Association mode.
3.
Follow your specific remote’s association steps.
4. Association is successful when all four LEDs on the DIN-9XWxR-MOD flash.
