Cervélo C SERIES, Manual, Page: 4 / 20

3
FORK PREPARATION
A
B
Max.
4mm
A 2.5mm spacer under
the Stem Cap is advised
1st Mark 2nd Mark /
Final Cut
C
D
E
F G
H
I
J
A. Stem Cap + 5mm bolt
B. Headset Spacers
C. Bearing Cap
D. Compression Ring
E. Bearings
F. Fork Insert
G. Two-Part Epoxy
H. Mixing Stick
I. Isopropyl Alcohol Wipe
J. Sandpaper (120 Grit)
1. Apply grease to the bearing seats, and Install the upper & lower
headset bearings into the head tube.
2. Fit the fork into the head tube with the complete headset,
required spacers, and the stem.
3. Apply the minimum pressure needed to ensure the assembly is
fully seated. Mark the steerer tube at the top of the stem.
4. Remove fork and clearly mark the fork steerer tube at a
point 4mm below the first mark. Take care to verify that this
measurement is correct as this defines the cut line for the
steerer tube.
Avoid breathing the dust created during cutting carbon
composite materials.
Do not exceed 50 mm maximum total spacer height,
including the bearing cap.