Chain Brake
This machine is equipped with an automatic brake to stop saw chain
rotation upon occurrence of kickback while in saw cutting operation.
The brake is automatically operated by inertial force which acts on
the weight fitted inside the front guard. This brake can also be
operated manually with the front guard turned down to the guide
bar.
To release brake, pull up the front guard toward the front handle till a
“click” sound is heard.
Be sure to confirm brake operation during the daily inspection.
To check the brake is working:
1.
Turn off the engine.
2. Holding the chainsaw horizontally, release your hand from the front handle, then hit the tip of the
guide bar on a stump or a piece of wood and confirm brake operation.
3. If the brake is not effective, please turn the chainsaw off and contact a service agent.
If the engine is kept operating at high speed with the brake engaged, the clutch will heat up causing further
trouble. When the brake is operated during use, immediately release your fingers from the throttle lever to
keep the engine idling.
Stopping the Engine
1.
Release the throttle lever to allow the engine idling for a few minutes.
2. Put the switch to the “O” (STOP) position. ( 1 = Switch)
Sawing
Before starting on your cutting job, read the “For Safe Operation” section. It is recommended to first
practice sawing on easy logs. This will also help you to get accustomed to your chainsaw.
•
Always follow the safety regulations. The chain saw must only be used for cutting wood. It is
forbidden to cut other types of material. Vibrations and kickback vary with different materials. Do
not use the chain saw as a lever for lifting, moving or splitting objects . Do not lock it over fixed
stands. It is forbidden to hitch tools or accessories to the chainsaw that are not specified by
Kogan.com.
•
It is not necessary to force the saw into the cut. Apply only light pressure while running the engine
at full throttle.
•
When the saw chain is caught in the cut, do not attempt to pull it out by force, but use a wedge or
a lever to open the way.
Guard Against Kickback
•
This saw is equipped with a chain brake that will stop the chain in the event of kickback if operating
properly. You must check the chain brake operation before each usage by running the saw at full
the throttle for 1-2 seconds and pushing the front hand guard forward. The chain should stop
immediately with the engine at full speed. If the chain is slow to stop or does not stop, replace the
brake band and clutch drum before use.
•
It is extremely important that the chain brake be checked for proper operation before each use and
that the chain be sharp in order to maintain the kickback safety level of this saw. Removal of the
safety devices. Inadequate maintenance, or incorrect replacement of the bar or chain may increase
the risk or serious personal injury due to kickback.
9
Summary of Contents for CTCHNSAW88A
Page 1: ......
