Extraction of dust and chips
Connect your tool to an extraction unit or vacuum cleaner. This will provide excellent
extraction of chips and dust from the workplace.
The benefits are that you will protect both the equipment and your health. Your work area
will also be clean and safe.
Attach the adapter for the dust extraction system to the connection for the dust
extraction system.
You can then connect a suitable vacuum cleaner (not supplied) to the dust extraction
system adapter.
Parallel stop
The parallel stop enables you to saw parallel lines.
Loosen the locking screw (9) for the parallel stop on the saw foot.
To assemble, slide the parallel stop into the guide on the saw foot.
Set the required spacing and then lighten the locking screw (9) again
Using the parallel stop: Position the parallel stop flat on the edge of the workplace
and start the cut.
Operation
Working with the electric mini circular saw
Always hold the electric mini circular saw firmly.
Do not use force! Push forward gently and evenly with the electric mini circular saw.
The waste piece should be on the left-hand side of the electric mini circular saw so
that the wide section of the support bench supports its full area.
If you are sawing down a line that has been drawn, guide the electric mini circular
saw along the corresponding notch.
Clamp small pieces of wood securely before sawing them. Never hold them with
your hand.
Always follow the safety instructions. Wear safety goggles.
Do not use defective saw blades or blades that are cracked or broken.
Do not use any flanges/flange nuts whose bore hole is larger or smaller than those in
the saw blade.
The saw blade must not be decelerated by hand or by applying lateral pressure to
Summary of Contents for 500W 85mm Mini Circular Saw
Page 1: ......