Fons Floor Lamp
Assembly Instructions
1st
2nd
Press the segments onto coupler. Secure
by fastening set screws as shown to the
left. Tighten only until set screws are flush
with the outside of the segments. You will
do this at 2 locations; closer to the mast
first, then the one closer to the socket.
Push the end of the boom up to give slack
to the cable.
Pull cable and insert into the thin slot on
top of the wood body. The plug on the
end of the cable should seat fully into the
hole.
Raise tube necklace assembly and insert
the first tube segment into the wood
body until fully seated. The screw should
be aligned and engaged in the slot.
Fons 8 has a short tip piece
Fons 10 has a long tip piece
(fons 10 shown)
3
4
2
2
5
5
4
5
Set height of lamp shade/light by pulling
or giving slack to power cord.
Determine height desired
13”
6
6
CERNOGROUP.COM
T: 949.715.1534
22892 GLENWOOD DRIVE, ALISO VIEJO, CA
COPYRIGHT 2021 CERNO LLC. ISSUE DATE 01/01/2021
