44
4.6 WDS Status
The Peers MAC Address, antenna 0/1 received signal strength, phy mode and channel
bandwidth for each WDS are available.
MAC Address :
Display MAC address of WDS peer.
RSSI :
Indicate the RSSI of the respective WDS's link.
TX/RX Rate :
Indicate the TX/RX Rate of the respective WDS's link
TX/RX SEQ :
Indicate the TX/RX sequence of the respective WDS's link
5. Client Repeater AP Mode Configuration
When Client Repeater AP Mode is chosen, the system can be configured as an Client
Repeater APMode. This section provides detailed explanation for users to configure in the
Client Repeater AP Mode with help of illustrations. In the Client Repeater AP
Mode, functions listed in the table below are also available from the Web-based GUI interface.
5.1 Chose Your Operating Mode(Client Repeater
AP)
The system administrator can set the desired mode via this page, and then configure the
system according to their deployment needs, Please click on
System -> Operating Mode
and
follow the below setting.
