1.
General rules PCI40-100
To prevent possible injury, read, understand and follow all warnings, safety precautions
and instructions before using the equipment.
Call your distributor if you have any questions
1.1.
Safety Precautions
Define the cutting area with a special shield and if possible reserve it for cutting/welding only.
Protect the body with an appropriate working outfit ( helmet for welding, gloves, rubber boots,
etc.)
The working outfit must be tight as much as possible without pockets.
Use an air-supplied respirator if ventilation is not adequate to remove all fumes and gases.
1.2.
Elektric safety rules
Never touch any parts that are electrically “live”
Wear dry gloves and clothing.
Insulate yourself from the work piece or other parts of the welding circuit.
Repair or replace all worn or damaged parts.
Extra care must be taken when the workplace is moist or damp.
Be sure that the machine is properly grounded to prevent electric shocks.
Never roll up the torch and the ground cables on the body.
Never operate in wet areas without taking precautions.
Never operate whith the cover taken off to prevent any damage on the machine and yourself.
1.3.
Fire and explosion
Be sure that in the cutting area a fire extinguisher is provided and verify its efficiency periodically.
Be sure there is no combustible or flammable material in the workplace. Any material that cannot
be removed must be protected.
Adapt all necessary safety rules in case of cutting to any containers of lubricating and fuel
materials.
