FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 83 of 597
3.5.3
Configuring the Radio Carriers
To configure the radio carriers:
1 Configure the carriers on both ends of the link to the desired frequency
channel. Both carriers must be configured to the same frequency channel.
2 Assign an XPIC (CCDP operational mode) support-enabled script to the
carriers on both ends of the link. Each carrier must be assigned the same
script. For details, refer to Configuring the Radio (MRMC) Script(s).
Note:
XPIC support is indicated by an X in the script name. For
example, mdN_A2828X_111_1205 is an XPIC-enabled script.
mdN_A2828N_130_100 is not an XPIC-enabled script. For a
list of XPIC support-enabled scripts, refer to the most recent
FibeAir IP-20C Release Notes.
3 In the XPIC page, create an XPIC group that consists of the two RMCs that
will be in the XPIC group. See Creating an XPIC Group.
3.5.4
Creating an XPIC Group
To create an XPIC group:
1 Select Radio > Groups > XPIC. The XPIC page opens.
Figure 53: XPIC Configuration Page
2 In the XPIC Configuration page, select Enable in the Admin state field and
click Apply.
To disable XPIC, select Disable in the Admin state field and click Apply.
