FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 352 of 597
3 Add members to the group as follows:
To add a radio interface to the group, enter the following command in
Multi-Carrier ABC Group view. Repeat this command for each radio
interface you want to add.
multi-carrier-abc group-id [1]> attach-member slot 2 port
<port> channel-id <1-16>
The Channel ID identifies the interface within the group.
4 Repeat for the second radio interface.
The following commands create a Multi-Carrier ABC group.
root> multi-carrier-abc create group group_id 1
multi-carrier-abc group-id[1]> attach-member slot 2 port 1
channel-id 1
multi-carrier-abc group-id[1]> attach-member slot 2 port 2
channel-id 2
multi-carrier-abc group-id[1]> exit
14.2.3
Removing Members from a Multi-Carrier ABC Group (CLI)
To remove members from a Multi-Carrier ABC group:
1 To remove an individual radio interface from the Multi-Carrier ABC group,
go to Multi-Carrier ABC group view and enter the following command:
multi-carrier-abc group-id[1]> detach-member channel-id
<channel-id>
14.2.4
Deleting a Multi-Carrier ABC Group (CLI)
To delete a Multi-Carrier ABC group:
1 Remove the members from the group. See Removing Members from a
Multi-Carrier ABC Group (CLI).
2 Delete the group by entering the following command in root view:
root> multi-carrier-abc delete group group_id 1
14.3
Configuring Link Aggregation (LAG) (Optional) (CLI)
Link aggregation (LAG) enables you to group several physical Ethernet or
radio interfaces into a single logical interface bound to a single MAC address.
This logical interface is known as a LAG group. Traffic sent to the interfaces in
a LAG group is distributed by means of a load balancing mechanism. IP-20
uses a distribution function of up to Layer 4 in order to generate the most
efficient distribution among the LAG physical ports.
This section explains how to configure LAG and includes the following topics: