FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 336 of 597
Password must include characters of at least three of the following
character types: lower case letters, upper case letters, digits, and special
characters. For purposes of meeting this requirement, upper case letters at
the beginning of the password and digits at the end of the password are
not counted.
The last five passwords you used cannot be reused.
See Configuring the Password Security Parameters (CLI).
In addition to the Admin password, there is an additional password protected
user account, “root user”, which is configured in the system. The root user
password and instructions for changing this password are available from
Ceragon Customer Support. It is strongly recommended to change this
password.
13.6
Configuring In-Band Management (CLI)
You can configure in-band management in order to manage the unit remotely
via its radio and/or Ethernet interfaces.
Each IP-20 unit includes a pre-defined management service with Service ID
257. The management service is a multipoint service that connects the two
local management ports and the network element host CPU in a single service.
In order to enable in-band management, you must add at least one service
point to the management service, in the direction of the remote site or sites
from which you want to access the unit for management. For instructions on
adding service points, see Configuring Service Points (CLI).
13.7
Changing the Management IP Address (CLI)
Related Topics:
Defining the IP Protocol Version for Initiating Communications (CLI)
Configuring the Remote Unit’s IP Address (CLI)
You can enter the unit's address in IPv4 format and/or in IPv6 format. The
unit will receive communications whether they were sent to its IPv4 address
or its IPv6 address.
To set the unit's IP address in IPv4 format, enter the following command in
root view to configure the IP address, subnet mask, and default gateway:
root> platform management ip set ipv4-address <ipv4-address>
subnet <subnet> gateway <gateway> name <name> description
<name>
Table 68: IP Address (IPv4) CLI Parameters
Parameter
Input Type
Permitted Values
Description
ipv4-address
Dotted decimal format.
Any valid IPv4 address.
The IP address for the unit.
subnet
Dotted decimal format.
Any valid subnet mask.
The subnet mask for the unit.
gateway
Dotted decimal format.
Any valid IPv4 address.
The default gateway for the
unit (optional).