FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 334 of 597
Note:
The IP-20 IP address, as well as the password, should be
changed before operating the system. See Changing the
Management IP Address (CLI) and Changing Your Password
13.2.1
PC Setup (CLI)
To obtain contact between the PC and the IP-20 unit, it is necessary to
configure an IP address on the PC within the same subnet as the IP-20 unit.
The default IP-20 IP address is 192.168.1.1. Set the PC address to e.g.
192.168.1.10 and subnet mask to 255.255.255.0. Note the initial settings
before changing.
Note:
The IP-20 IP address, as well as the password, should be
changed before operating the system. See Changing the
Management IP Address (CLI) and Changing Your Password
(CLI).
13.3
Logging On (CLI)
Use a telnet connection to manage the IP-20 via CLI. You can use any standard
telnet client, such as PuTTy or ZOC Terminal. Alternatively, you can simply use
the
telnet <ip address>
command from the CMD window of your PC or
laptop.
The default IP address of the unit is 192.168.1.1. Establish a telnet connection
to the unit using the default IP address.
When you have connected to the unit, a login prompt appears. For example:
login:
At the prompt, enter the default login user name:
admin
A password prompt appears. Enter the default password:
admin
The root prompt appears. For example:
login: admin
Password:
Last login: Mon Apr 13 11:27:02 on console
IP20C
root>
13.4
General CLI Commands
To display all command levels available from your current level, press <TAB>
twice. For example, if you press <TAB> twice at the root level, the following is
displayed:
root>
auto-state-propagation ethernet exit multi-carrier-abc
platform quit radio radio-groups
switch-back switch-to wait