FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 168 of 597
9 In the Default CoS field, enter a default Class of Service (CoS) value (0-7).
This value is assigned to frames at the service level if CoS Mode is set to
Default-CoS. Otherwise, this value is not used, and frames retain whatever
CoS value they were assigned at the service point or logical interface level.
10 In the CoS Mode field, select one of the following options. This parameter
determines whether or not frames passing through the service have their
CoS modified at the service level. The CoS determines the priority queue to
which frames are assigned.
Default CoS – Frames passing through the service are assigned the
default CoS defined above. This CoS value overrides whatever CoS may
have been assigned at the service point or interface level.
Preserve-SP-COS-Decision – The CoS of frames passing through the
service is not modified by the service's default CoS.
11 Click Apply, then Close to close the Ethernet Services - Add page.
12 Add service points. You must add service points to the service in order for
the service to carry traffic. See Configuring Service Points.
6.1.5
Editing a Service
To edit a service:
1 Select Ethernet > Services. The Ethernet Services page opens
2 Select the service in the Service Configuration Table.
3 In the Ethernet Services page, click Edit. The Ethernet Services - Edit page
opens.
This page is identical to the Ethernet Services - Add page (Figure 118). You can
edit any parameter that can be configured in the Add page, except the
Service ID.
6.1.6
Deleting a Service
Before deleting a service, you must first delete any service points attached to
the service.
To delete a service:
1 Delete all service points attached to the service you wish to delete, as
described in Deleting a Service Point.
2 Select Ethernet > Services. The Ethernet Services page opens
3 Select the service in the Ethernet Service Configuration Table.
4 Click Delete. The service is deleted.
