User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 546 of 825
Ceragon Proprietary and Confidential
To set the RSL thresholds, enter the following command in radio view:
radio [x/x]>rf pm-rsl set threshold1 <threshold1> threshold2
<threshold2>
Table 117: RSL Thresholds CLI Parameters
Parameter
Input Type
Permitted Values
Description
threshold1
Number
-75 - -15
The first RSL threshold
(dBm).
threshold2
Number
-75 - -15
The second RSL
threshold (dBm).
The following command sets the RSL thresholds to -30 dBm and -60 dBm,
respectively.
radio [2/1]>rf pm-rsl set threshold1 -30 threshold2 -60
16.6.5
Configuring TSL Thresholds (CLI)
The number of seconds during which the TX Signal Level exceeds the TSL
threshold are counted as TSL Exceed Threshold Seconds. See
To set the TSL threshold, enter the following command in radio view:
radio [x/x]>rf pm-tsl set threshold -15
Table 118: TSL Thresholds CLI Parameters
Parameter
Input Type
Permitted Values
Description
threshold
Number
-10 - 34
The TSL threshold
(dBm).
The following command sets the TSL threshold to 10 dBm:
radio [2/1]>rf pm-tsl set threshold 10
16.6.6
Displaying RSL and TSL Levels (CLI)
You can display the RSL (RX Signal Level) and TSL (TX Signal Level) PMs in either
15-minute or daily intervals.
To display RSL and TSL PMs in 15-minute intervals, enter the following command
in radio view:
radio [x/x]>rf pm-rsl-tsl show interval 15min
To display RSL and TSL PMs in daily intervals, enter the following command in
radio view:
radio [x/x]>rf pm-rsl-tsl show interval 24hr
The following is the output format of the
rf pm-rsl-tsl show
commands:
