User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 294 of 825
Ceragon Proprietary and Confidential
◦
To display reports for the past 24 hours, in 15 minute intervals, select
15
minutes
.
◦
To display reports for the past month, in daily intervals, select
24 hours
.
describes the Ethernet RX port PMs.
Table 53: Ethernet RX Port PMs
Parameter
Definition
Interval
For 24-hour intervals, displays the date of the interval. For 15-minute
intervals, displays the date and ending time of the interval.
Peak... Average...
bytes... Packets...
Various peak transmission rates (per second) and average RX rates (per
second), both in bytes and in packets, for each measured time interval.
RX bytes Layer 1
exceed threshold
(sec)
The number of seconds the RX bytes exceeded the specified threshold
during the interval. For instructions on setting the threshold, see
the Ethernet Port RX Threshold
Invalid data flag
Indicates whether the values received during the measured interval are
valid. An x in the column indicates that the values are not valid (for
example, because of a power surge or power failure that occurred during
the interval).
To clear the PMs, click
Clear All
.
6.5.4.2
Enabling or Disabling Gathering of Port RX PM Statistics per Interface
To select the interfaces for which to gather and display Port RX PMs:
1 In the Ethernet Port RX PM Report page, click
PM Admin
. The Ethernet PM
Port Admin page opens.
Figure 218: Ethernet PM Port Admin Page
2 Select the interface.
