Changer can only be used when bassinet is
installed in Playard.
1
Lay changer on flat surface.
2
Grasp middle of each long
side and gently pull apart until
short sides
“click”
and
lock
in
place.
NOTE:
Make sure changer
sides are fully extended and
locked.
3
With vinyl side facing up,
insert two (2)
“T-Fittings”
on changer into
“T-Slots”
in bassinet and push down
to secure.
4
Push
Triangular Tabs
into
Triangular Holes
in
Playard corners.
5
Secure changer to Playard:
• Pass
Attachment Strap
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
Repeat for other strap.
6
Unfold
Changer Storage Area
so it hangs over top rail.
CAUTION:
DO NOT place supplies weighing more
than 2.3 kg (5 lbs.) in changer storage area.
Changer is now ready for use.
ASSEMBLY and USE continued
6
Changer
Triangular
Tab
T-Fitting
T-Fitting
T-Slot
Attachment
Strap
Changer
Storage Area
WARNING
Avoid serious injury or death:
• Always use restraint belt to prevent falls.
• Use changer with infant who weighs less
than 8.2 kg (18 lbs.) and is less than
63.5 cm (25 inches) tall.
• Discontinue use of changer if infant can
push up on hands and knees or sit
unassisted.
•
DO NOT
carry changer with infant in it.
Triangular
Hole
Triangular
Tab
