9
9
105
Sliding Latch Plate and
Switchable Retractor
A latch plate that slides
freely on the belt webbing
and cannot, by itself, hold
the belt snug around a car
seat.
When installing the car
seat, route the vehicle seat
belt through the proper
belt path and buckle it in.
Slowly pull the shoulder
belt all the way out to
switch it to locking mode.
Then, as you pull the
vehicle seat belt tight, feed
all the slack back into the
retractor.
Grab the sides of the seat
at the belt path and slide
side to side and front to
back. The seat should not
move more than 1” (2.5
cm).
Note: With the vehicle seat
belt in this locking mode, all
the tension is upwards in the
shoulder belt. This may start to
tilt your car seat sideways when
rear-facing. If this happens, use a
locking clip instead of switching
the retractor. See Sliding Latch
Plate and ELR Retractor.
How to Lock Your Lap/Shoulder Vehicle Seat Belt
Summary of Contents for Drive On
