NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
Page 11
For technical questions, please call 1-888-866-5797.
Item 95923
S
AFETY
Op
E
r
A
TIO
n
M
AI
n
TE
n
A
n
CE
S
ET
up
Operating Instructions
read the EnTIrE IMpOrTAnT SAFETY InFOrMATIOn section at the beginning of
this manual including all text under subheadings therein before set up or use of this
product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Workpiece and Work Area Set up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the air hose along a safe
path to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
3. Before spraying, mask nearby
objects not being sprayed and lay
cloths (not included) on the floors.
4. Prepare the workpiece according to
paint manufacturer’s directions.
Airbrush Setup and Adjustment
TO prEVEnT SErIOuS InJurY:
Do not adjust or tamper with any control or component in a way not specifically explained
within this manual. Improper adjustment can result in tool failure or other serious hazards.
CAuTIOn! Keep hands away from Trigger while making adjustments.
IMpOrTAnT:
Only used paints
designed for use with an Airbrush.
note:
Proper paint mixture is essential.
Follow the manufacturer’s directions. Most paints
will spray easily if they are thinned properly.
1. Thin the paint according to manufacturer’s
directions and mix thoroughly.
2. Carefully strain the paint
through a paint strainer.
3. Fill the Jar to no more than 3/4 full.
Thread the Lid onto the Jar.
4. Thread the Air Hose onto the
Airbrush’s Air Inlet.
5. Gently push the Fitting on the Lid into
the Color Stem on the Airbrush.
note:
The Jar is held in place
with friction, not threading.
6. Start the air compressor and set
the regulator to needed pressure.
Do not exceed maximum air pressure.
note:
To avoid clogging, start with the lowest
pressure, increasing pressure if needed.
7. Test the consistency by spraying
on a piece of scrap material.
note:
Adjust the Air Pressure Valve(s)
to regulate spray consistency.
