Page 5
SKU 97007
For technical questions, please call 1-800-444-3353.
c.
do not use the tool if the switch
does not turn the tool on or off.
Any tool that cannot be controlled
with the switch is dangerous and
must be repaired.
d.
disconnect the tool from the air
source before making any adjust-
ments, changing accessories, or
storing the tool.
Such preventive
safety measures reduce the risk of
starting the tool unintentionally. Turn
off and detach the air supply, safely
discharge any residual air pressure,
and release the Safety Paddle Switch
and/or turn the switch to its off posi-
tion before leaving the work area.
e.
Store the tool when it is idle out of
reach of children and other un-
trained persons.
A tool is dangerous
in the hands of untrained users.
f.
Maintain the tool with care.
Keep a
cutting tool sharp and clean. A prop-
erly maintained tool, with sharp cut-
ting edges reduces the risk of binding
and is easier to control.
g.
check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition that
affects the tool’s operation.
If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
h.
use only accessories that are
identified by the manufacturer for
the specific tool model.
Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
Service
a.
tool service must be performed
only by qualified repair personnel.
b.
When servicing a tool, use only
identical replacement parts. use
only authorized parts.
c.
use only the lubricants supplied
with the tool or specified by the
manufacturer.
air source
a.
never connect to an air
source that is capable of
exceeding 200 psi.
Over
pressurizing the tool is
able to result in bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only
clean, dry, regulated compressed air
at the rated pressure or within the
rated pressure range as marked on
the tool. Always verify prior to using
the tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range.
b.
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SaVe tHeSe
inStRuctionS.
