Page 4
SKU 96445
for technical questions, please call 1-800-444-3353
setup
recommended air line components
palm grip
sander
air
compressor
For best service you should incorporate an oiler, regulator, and inline filter, as shown in
the diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
note:
If you are not using an automatic oiler system, before operation, add a few drops of
Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour of
continual use.
You will need to prepare a
1
/
4
” male air connector (not included) to be attached to the
Inlet Connector on the Palm Grip Sander. Wrap the
1
/
4
” air connector with pipe thread
seal tape before threading it into the Inlet. Connect the
3
/
8
” ID Air Hose to a quick con-
nect coupler (not included), and then to the Sander.
Set the air pressure on the regulator to 90 PSI.
do not exceed the recommended
air pressure of 90 psi
.
Check the air connection for leaks.
1.
2.
3.
warning: the brass components of this product contain lead, a chemical known
to the state of california to cause birth defects (or other reproductive harm).
(california Health & safety code § 25249.5, et seq.)
warning: the warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur.
It
must be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
note:
Performance of the compressor (if powered by line voltage) may vary depending on varia-
tions in local line voltage. Extension cord usage may also affect tool performance.
unpacKing
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
20.
21.
