Page 5
SKU 97526
95882
For technical questions, please call 1-800-444-3353.
UNPACKING AND SET UP
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram on page 9 of this manual.
WARNING! Make sure the tool is unplugged from its air supply before making
any adjustments to the tool. Also make sure the Magazine (47 and 51) are empty
before set up or maintenance.
Figure 1
NOTE: For best service, you should incorporate an oiler, regulator, and in-line filter
as shown in Figure 1 above. Hoses, couplers, oilers, regulators and filters are all
available at Harbor Freight Tools.
If you are not using an automatic oiler system, before operation add a few drops of
Pneumatic Tool Oil (not included) to the airline connection. Add a few drops after
each hour of continual use.
Set the air pressure range on the regulator so that it is between 60 and 100 PSI.
Do not exceed 100 PSI.
LOADING THE NAILER
1.
Depress upper tip of the Click Lever (59). The Side Cover (34) will pop open.
2.
Insert a row of fasteners (not included) into the Upper Right Magazine (47/51). Make
sure the pointed ends of the fasteners are loaded with the points downward. Also
make sure fasteners are not dirty or damaged.
3.
Slide the Side Cover (34) back over the Upper Magazine (47/51) and press the
upper tip of the Click Lever (59) in ward to lock Side Cover (34) in place.
Air Coupler