SKU 67100
For technical questions, please call 1-800-444-3353.
Page 13
off the roller and the spring will roll up
with a snap, possibly pinching your
finger.
4. Pull out the jammed fastener and the
remainder of the fastener strip that is
still in the magazine. Dispose of the
remaining fastener strip; it may be
bent or damaged in some other way.
5. If you are unable to clear the fastener
jam using the method prescribed
above, the tool should be taken to a
qualified service technician for proper
servicing.
Troubleshooting
Problem
Possible Causes
Likely Solutions
Insufficient
fastener depth.
1. Not enough air pressure.
2. Incorrect lubrication or not
enough lubrication.
3. Blocked air inlet screen.
4. Mechanism contaminated.
1. Check the pressure setting on the regulator
gauge.
Do not exceed maximum air
pressure.
2. Lubricate using air tool oil and grease
according to directions.
3. Clean air inlet screen of buildup.
4. Have qualified technician clean and lubricate
mechanism. Install in-line filter in air supply
as stated in Initial Set Up: Air Supply.
Fasteners drive
too deeply.
1. Too much air pressure.
1. Reduce air supply pressure (PSI).
Tool cycles
without firing
fastener.
1. Jammed fastener.
2. Incorrect fasteners used.
3. Magazine dirty or not
lubricated properly.
4. Insufficient air flow.
1. Clear jammed fastener according to Clearing
Jams instructions.
2. Empty, then fill with correct fasteners.
3. Clean and lubricate magazine and pusher.
4. Check for loose connections and make
sure that air supply is providing enough air
flow (CFM) and pressure (PSI) to the tool’s
air inlet.
Do not exceed maximum air
pressure.
Frequent
jamming.
Incorrect fastener type.
Confirm fastener diameter, type, length, angle,
and collation type. Correct as needed.
Severe air
leakage.
1. Cross-threaded housing
components.
2. Loose housing.
3. Damaged valve or housing.
4. Dirty, worn or damaged valve.
1. Check for incorrect alignment and uneven
gaps. If cross-threaded, disassemble and
replace damaged parts before use.
2. Tighten housing assembly. If housing cannot
tighten properly, internal parts may be
misaligned.
3. Replace damaged components.
4. Clean or replace valve assembly.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect
air supply before service.
Record Product’s Serial Number Here:
Note:
If product has no serial number, record month and year of purchase instead.
Note:
Some parts are listed and shown for illustration purposes only, and are not available individually as replace-
ment parts.