Page 4
SKU 99989
For technical questions, please call 1-800-444-3353.
Functions
This tool can be used to vacuum dust
1.
and small debris from a shop floor,
when a 4” flexible hose (not included)
from the shop dust collection system
is attached.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Upper Handle Section (13) must be
1.
attached to Lower Handle Section (8)
prior to use.
Insert Upper Handle Section (13) into
2.
Lower Handle Section (8) and fasten
together using Phillips Head Screw
(15).
opeRAting inStRuctionS
Read the entiRe
iMpoRtAnt SAFety
inFoRMAtion section at the
beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
Before operating the Rolling Sweep,
1.
put on ANSI-approved safety goggles
and other safety gear which are sold
separately.
to Attach a Flexible Vacuum Hose
The Swivel Connecting Tube (5) is
1.
designed to accept a standard 4” flex
-
ible collection hose (not included).
Insert your flexible hose into the Con
-
2.
necting Tube (5). If necessary, use a
band clamp or adapter (not included)
to secure the hose.
operating the Sweep
The Handle Assembly (8, 13) is de-
1.
signed to swivel on the Connecting
Tube (5).
To adjust the swivel angle, loosen
2.
the Knob (4), move the Handle to the
desired position, and retighten the
Knob.
The Supporting Tube (11) provides
3.
support by pushing on the top of the
Dust Hood (1) as the tool is used.
After attaching the 4” flexible hose,
4.
turn on the shop dust collection sys-
tem (not included). The Sweep will
now operate.
Roll the sweep along the shop floor to
5.
pick up dust and small debris.
Pick up large debris by hand to pre-
6.
vent clogging the Dust Hood (1). If
the Dust Hood becomes clogged,
turn off the dust collection system and
clear the Dust Hood.