Page 12
For technical questions, please call 1-888-866-5797.
Item 93012
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Mounting plain Ended Blades
Included as an accessory are two Plain End
Blade Adapters. When installed, they enable
the mounting of plain end saw blades (not
included). To install blades of this type:
1. Using a Hex Wrench, loosen both set screws
on each of the Plain End Blade Adapters.
2. Slide the gap between the two set
screws over each end of the blade.
3. Evenly tighten all set screws. Pull on the
Adapters slightly to make sure they are secure.
4. Remove the old blade. Pull the Insert out and
rotate it 90° to the position shown at right.
5. Loosen the Blade Tension Knob (21) by turning
counterclockwise about two full turns.
6. Place the Blade Adapter’s bar under the end of
the Lower Blade Holder (40). Make sure that
the blade’s teeth point the right direction.
7. Push down slightly on the Upper Rocker Arm (29),
and place the Blade Adapter’s other bar over
the end of the Upper Blade Holder (37).
8. Tighten the Blade Tension Knob (21) by
turning clockwise about two full turns.
