SKU 92258 For technical questions please call 1-800-444-3353. Page
4
Handle (3)
Metal Support (6)
Threaded Post (7)
Saddle (1)
Figure 1
Figure 2
Saddle (1)
Lock Pin (2)
6.
Thread the Holder (19) down into the Base (21)-see Figure 3.
7.
Set the Metal Support (6) down into the Holder (19). Insert Stop Pin (16) through Washer
(20) and insert it through the Holder (19) and Metal Support (6). Slide on second Washer
(20). Secure the Stop Pin in Place with Retaining Pin (18)-see Figure 3.
Metal Support (6)
Holder (19)
Stop Pin (16)
Washer (20)
Retaining Pin (18)
8.
Set the leg of the Foot Pedal (14) into the slot between the bars on the Holder (19). Slide a
Washer (20) onto the Stop Pin (15). Slide the Stop Pin (15) through the bar, the Foot Pedal
leg and through the outside bar. Slide on second Washer (20). Thread on Retaining
Pin (18).
Operation
1.
Make certain that the automotive part that you are working on is fully supported by
chains, straps and hoists. The Underhoist Stand is not designed to solely support
heavy components.
2.
Set the Underhoist under the load to be worked on. Turn the Handle (3) counterclockwise to
raise and clockwise to lower the Saddle (1) of the Underhoist.
3.
Set the Underhoist under the appropriate lifting points as indicated by the vehicle’s owner’s
manual. Center the load on the Saddle (1) and continue to turn the Handle (3) to bring the
Saddle (1) into full contact with the load to be supported.
4.
Use the Foot Pedal (14) to jiggle the Saddle (1) while making minor adjustments to the
load. This is the only purpose of this Underhoist Stand. Never attempt to use the
Underhoist Stand to support a load.
5.
Reverse the order of steps one through five to lower the Underhoist. Make certain that
at all times the load is fully supported by other means than the Underhoist Stand.
Foot Pedal (14) leg
Stop Pin (15)
Washer (20)
Retaining Pin (18)
Figure 3
