Page 8
For technical questions, please call 1-888-866-5797.
Item 62501
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
The two mounting holes in the Base can be used
to attach this Grinder to a stable workbench
using appropriate hardware (sold separately).
1. Install Right Work Rest (60) to the
Right Wheel Guard (43). Use Bolt (57),
Spring Washer (47), and Flat Washer (58)
to secure it in place, as shown in Figure A.
Right
Work
Rest (60)
Bolt (57)
Flat Washer
(58)
Spring
Washer (47)
Figure A: Work Rest Installation
2. Install Left Work Rest (59) to the
Left Wheel Guard (9) using Bolt (57), Spring
Washer (47), and Flat Washer (58).
3. Adjust the Work Rests to within 1/16″ of the
Grinding Wheel. To adjust this distance,
loosen Bolts (57) and move Work Rests (59/60).
4. Attach a Spark Guard (62, 63) to
each Wheel Guard (9,43) using a
Bolt (66), Spring Washer (65) and Flat
Washer (64) as shown in Figure B.
5. Adjust each Spark Guard (62, 63) to within
1/16" (0.0625") of the Grinding Wheel
and tighten each Bolt (66).
Knob (12)
Shield
Arm (67)
Spark
Guard
(62)
Figure B: Spark Guard and
Right Shield Arm Installation
6. Attach the Right Eye Shield Arm (67) to the
Right Wheel Guard (43) using an Eye Shield
Mounting Knob (12) and Washer (11), see Figure B.
7. Attach the Left Eye Shield Arm (10) to the
Left Wheel Guard (9) using an Eye Shield
Mounting Knob (12) and Washer (11).
8. Attach the Eye Shields (21) to the Eye
Shield Arms (10, 67) using Screws (13),
Spring Washers (14), Flat Washers (15),
and Nuts (16) as shown in Figure C.
Knob (12)
Shield
Arm (67)
Eye Shield
(21)
Screw (13)
Spring Washer (14)
Flat Washer (15)
Nut (16)
Figure c: Right Eye Shield Installation
