9.
Do not overreach
. Keep proper footing and balance at all times. Do not reach over or
across running machines.
10.
Maintain tools with care
. Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories. Inspect tool cords periodi-
cally and, if damaged, have them repaired by an authorized technician. The handles must
be kept clean, dry, and free from oil and grease at all times.
11.
Stay alert
. Watch what you are doing; use common sense. Do not operate any tool when
you are tired.
12.
Check for damaged parts
. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts or
mounting fixtures; and any other condition that may affect proper operation. Any part that
is damaged should be properly repaired or replaced by a qualified technician.
13.
Replacement parts and accessories
. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use accessories intended for use
with this tool. Approved accessories are available from Harbor Freight Tools.
14.
Do not operate tool if under the influence of alcohol or drugs
. Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking drugs.
If there is any doubt, do not operate the tool.
Unpacking
When unpacking, check the Parts Diagram and Part Number Listing on page 5 to make
sure all parts are included. If any parts are missing or broken, please call Harbor Freight Tools
at the number on the cover of this manual.
Note: The warnings and instructions contained in this instruction
manual cannot cover all possible conditions and situations that may
occur when using this product. It must be understood that common
sense and caution are factors which cannot be built into this product.
These factors must be supplied by the person operating the tool.
Assembling the Wheel Balancer
The Wheel Balancer is easily assembled by following the steps shown below. Part numbers
used below refer to the Parts Diagram and Part Number Listing on page 5.
1. Insert the threaded end of the Shaft (#9) into the Base (#12). Use Flat Washer (#11), Lock
Washer (#13) and two Nuts (#10) to tightly secure the Shaft - see the Parts Diagram for proper
assembly order of hardware.
#39741
For technical questions, please call 1-800-444-3353.
Page 3
