For technical questions, please call 1-800-444-3353.
SKU 38123
Page 10
2.
Set the Worktable (35) on its side, and align its mounting holes with the mounting holes
in the Table Support (36). (See Figure F.)
3.
Attach the Table Support (36) to the Worktable (35) using the Hex Screws (6), Lock
Washers (7), and Flat Washers (8). (See Figure F.)
4.
Position the Table Support (36) in the corresponding mounting holes located on the
side of the Base (42). (See Figure G, next page.)
5.
Place a Flat Washer (8) on the shaft of the Knob (1). Then, screw the Knob into the
threaded hole in the Base (42). (See Figure G.)
6.
Loosen the three Hex Screws (6), and adjust the Worktable (35) so there is a maximum
of
1
/
16
” space between the Sandpaper Pad (27) and the Worktable. Then, retighten the
Hex Screws. (See Figures F and G.)
TABLE SUPPORT (36)
WORKTABLE (35)
LOCK WASHER (7)
HEX SCREW (6)
FIGURE F
FLAT WASHER (8)
