SKU 95203 For technical questions please call 1-800-444-3353.
Page 4
5.
From the underside of the workbench, put the appropriate size washers, lock washers
and nuts on the bolts. Repeat these steps for the second mounting hole. Tighten all the
nuts, securing the Vise to the workbench. This will mount it in a permanent position.
See Figure 2.
Handle (7)
Back Jaw
with Clamp (1)
Front Jaw (2)
T-Handle (4)
Back Jaw (1)
Figure 1
Mounting
Holes (Qty. 2)
Back Jaw (1)
Mounting
Hole
Figure 2
Figure 3
USING UNmOUNTED CARPENTER’S VISE
1.
Choose the location for working with the unmounted Vise. Attach the Back Jaw with
Clamp (1) by turning the T-Handle (4) clockwise until the Bushing (5) (not shown) is
flat against the under side of the workbench. Tighten securely.
See Figure 3.
2.
Turn the Handle (7) counterclockwise to open the Front Jaw (2) of the Vise. Place the
work piece inside the Jaws. Tighten the Jaws against the work piece by turning the
Handle (7) clockwise until your work piece is held securely against the Jaws (1 & 2).
Caution:
Damage could occur to your work piece if you overtighten the Handle (7).
Pads or pieces of hardwood stock (not included) can be attached to the Jaws (1 & 2)
for further protection to your work piece.
See Figure 3.
3.
To remove the object you are working on, turn the Handle (7) counterclockwise
two to three times, opening the Jaws (1 & 2). Remove your work piece.
