Manufactured for and on behalf of Wolseley UK Limited,
2 Kingmaker Court, Warwick Technology Park,
Gallows Hill, Warwick, Warwickshire,
United Kingdom, CV34 6DY
Hereby, Wolseley UK Limited declares that this product is in
compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following
internet address:
http://www.wolseley.co.uk
Receiver Category 2
Max RF Power: 25mW
868-868.6MHz
(EU) 811/2013
Whilst every care has been taken to ensure that the information included in this document
was accurate at the time of printing, we reserve the right to change specifications at any time.
The photographs reproduced in this publication are within the constraints of the printing
process and are NOT to be used for matching purposes. E&OE.
For further information telephone 0344 292 7060
www.wolseley.co.uk
IG-340017.v01
WEEE Directive 2012/19/EU
At the end of the product life dispose
of the packaging and product in a
corresponding recycling centre. Do
not dispose of the unit with the usual
domestic refuse. Do not burn the product.
The binding operation described below is required if:
• Any of the system components (Wireless Thermostat or Receiver Box) are replaced.
• The Receiver Box has incorrect or no binding data stored (e.g. when pre-bound system pack
components have been mismatched).
NOTE:
During the binding procedure keep approximately 1m distance between the Wireless Thermostat
and the Receiver Box.
1.
Press and hold the Receiver Box push button for 15 seconds to reset any previously stored data.
After 15 seconds the red LED will change to flashing 0.1sec on/0.9sec off.
NOTE:
After 5 seconds the red LED will start to flash 0.5sec on/0.5sec off, but continue to hold the button).
2.
Release the push button.
3.
Press and hold the Receiver Box push button for 5 seconds to enter the binding mode.
The Red LED will start flashing at 0.5sec on/0.5sec off to confirm the binding mode has been entered.
4.
On the Wireless Thermostat press and hold MENU
and for 3 seconds to enter the binding screen
with parameter 14A flashing
If 1 is shown then it is already bound to a Receiver Box. If 0 is shown then there are no Receiver Box bounded
5.
To bind to a new Receiver Box, Press
to enter the binding sub menu.
6.
Press or to scroll to 1 and press
again. After few seconds the binding result will be displayed
on the screen with 1 representing successful bind, 0 representing failure.
If successful the red LED on the Receiver Box is switched off to confirm successful binding operation.
Binding / Rebinding
