Page 7
Installation
CONNECTING TO ELECTRICAL POWER cont’d.
Units Without Power Cord or Plug: Have a licensed electrician connect the unit to the power supply.
9. Complete the warranty registration online at www.globeslicers.com/warranty.asp.
10. Clean the mixer prior to using it. Follow the cleaning instructions on page 11.
NOTE: It is normal for the factory to apply a generous amount of grease in and on the machines before initial
use. Excess grease (brown in color) will be on all metal surfaces (e.g. top portion of bowl guard, speed
control, bowl clamps, bowl lift lever, and attachment hub thumbscrew). Excess high-pressured grease
(brownish-black) may also be found on the planetary shaft and some drippings may be found in the bowl.
Operating Instructions
TO AVOID SERIOUS PERSONAL INJURY:
• DO NOT
remove the bowl guard.
•
DO NOT
operate the mixer before reading the instruction manual first.
•
ALWAYS
disconnect or unplug electrical power before cleaning, servicing, or adjusting any parts or
attachments.
•
ALWAYS
keep hands, hair, and clothing away from moving parts.
ATTACHING THE BOWL TO THE MIXER
NOTE: Install the bowl BEFORE attaching the agitators.
1. Lower the bowl by pulling the bowl lift lever forward and down to its resting position. For
the MAC60, rotate the bowl lift wheel counterclockwise until it stops.
2. Lift the bowl by the bowl handles and
a. slowly position the locking pin (located on the rear of the bowl) into the hole in the
middle rear of the cradle (see fig 7-1).
b. lower the bowl onto the pins located on either side of the bowl cradle.
3. Once the bowl is positioned on the cradle, secure the bowl by pulling each bowl clamp
forward until the bowl is locked tight (see fig 7-2).
Fig. 7-1
Fig. 7-2
Summary of Contents for MAC20
Page 2: ......